VALUELAM 4500HC-2 Instructions d'exploitation

DO NOT DISCARD BOX! (If for any reason you need to ship your machine back and you discard your box you will be responsible for purchasing another one)

10 Thermal Laminating... 1. Be sure all laminator parts (i.e. safety shield, feed table, etc.) are in their proper positions and the laminating fi

11 6. Allow the ValueLam 4500HC-2 to run a small amount of film before feeding the print into the laminator to avoid a dwell line across you

12 5. Turn the MOTOR switch ON and perform a test mount to ensure proper settings for successful mounting. If any adjustments are ne

13 Adjusting Rewind and Take-up Clutches 1. Remove plastic plug from cover. 2. Run motor until Phillips head screw is aligned with plug opening

14 3. Raise the roller pressure adjustment arms to the open position and insert pins on the side of the laminator and pull the film out of the unit

15 ACTION: Loosen tension on side (top or bottom) film is curling toward. PROBLEM: Laminated item is wrinkled ACTION: Increase mandrel tensio

16 Warranty & Return Policy... Warranty: Your laminator is warranted to be free of defects in material and workmanship for a period of 1 yea

2 READ BEFORE OPERATING CAUTION... TO AVOID ANY DAMAGE, PLEASE DO NOT USE RAZORS OR SHARP OBJECTS NEAR THE ROLLERS. DO NOT LEAVE MACHINE ON

3 Table of Contents For Your Safety... 4 Electrical Safeguards... 4-5 Specifi

4 OPERATING INSTRUCTIONS VALUELAM 4500HC-2 For your safety...  Do not connect the laminator to electrical power or attempt to operate it unt

5  Do not leave the laminator power on for extended periods while not in use. Unplug the machine at the end of the day as a precaution agai

6 Appropriate Location: The laminator must be placed on a sturdy table or stand in a clean, well lit area with ample space on all four sides of the

7 increase tension. This action clamps the brake on the mandrel axle creating tension necessary to achieve good results. Threading thermal Film: Y

8 8. Turn the SPEED CONTROL knob far enough to allow the rollers to sufficiently pull the poster board or cardboard into the laminator. Keep

9 Pressure Sensitive (PS) Film Loading 1. Place the roll of single sided PS film on the top supply mandrel. Orient it the same way you would poly i